| Snapshot | |
| TAKE | Stores the current aircraft parameters in the current snapshot number (as shown on Snapshot page). |
| Reposition | |
| GATE | Repositions aircraft at the gate. |
| HOLD POINT | Repositions aircraft at the holding point for the currently active runway. |
| TAKE OFF | Repositions aircraft at the take-off position on the currently active runway. |
| OPP TAKE OFF | Repositions aircraft at the take-off position at the opposite end of the currently active runway. |
| FINAL 4Nm, 7Nm, 12Nm | Reposition the aircraft on final approach to the currently active runway at 4, 7 or 10 Nm out. |
| Pushback | |
| NOSE LEFT | Pushback. Aircraft is reversed from ramp and aircraft tail turned through 90° to the right. |
| STRAIGHT | Aircraft is reversed straight back from the ramp. |
| NOSE RIGHT | Pushback. Aircraft is reversed from ramp and aircraft tail turned through 90° to the left. |
| Crash | |
| INHIBIT | Disables crash monitoring system so that the simulation does not stop if one of the in-air crash conditions is detected. |
| RESET | Following a crash, resets the aircraft to the take-off position on the currently active runway. |
