Instructor Operating

SNAPSHOT (1 of 2)

This page is selectable from the Master Index page.
The snapshot system allows you to record the condition of the simulator during a flight so that you can re-configure the simulator to that condition at a later time in order to repeat an exercise or incident. The system is capable of storing ten selectable snapshots.

NUMBER	Displays a pop-up menu to allow you to select the number of the snapshot which is to be used to store the snapshot data.
TAKE	The simulator conditions are stored in the snapshot and displayed on the page.
RECALL	Resets the simulator to the configuration specified by the selected snapshot (as shown in the SNAPSHOT display).
LOCK	Locks the data in the selected snapshot so that it cannot be erased. Second selection unlock the data.
ERASE	Erases the data from the selected snapshot (only available if not locked).
ERASE ALL	Erases the data from all the unlocked snapshots.
ACTUAL VALUE	Displays the current value of the listed parameters.
SNAPSHOT VALUE	Displays the stored values of the listed parameters for the selected snapshot.

Taking Snapshots

Select NUMBER and from the pop-up displayed, select the number (between 1 and 10) of the snapshot where you want to store the data.
If the snapshot slected contains data, the snapped values are displayed on the page. If you no longer require this snapshot, select ERASE to clear the data. If you do want to retain the snapshot, select another number.
Select TAKE. The simulator conditions are stored in the snapshot and displayed on the page.

NOTE: Armed malfunctions are not recorded as part of the snapshot as they are not active and do not for part of the current state of the simulator.